kurdishmob (December 31, 1969 at 6:59 pm)

dose anyone know if i can use a Ignition Coil Pack from a car engine to boost up the voltage of my circuit..or the ignition coil cant handle high frequency pulses.?

kurdishmob (December 31, 1969 at 6:59 pm)

im tryin to build a lawton pwm but dont know the voltage ratings for the 10nf,100nf, and 220nf caps.......dose it even matter? someone pls help

HMrox21 (December 31, 1969 at 6:59 pm)

Try submerging your plates in a pvc tube to help strip the gases, I used a 7ft tube and the gases jet up from the plates due to the pressure differences.

freeenergy4everyone (December 31, 1969 at 6:59 pm)

Am i right in thinking the water cell is charging then discharging, but never completely discharging? Given the scope readings never drop to zero?

RFvideoProductions (December 31, 1969 at 6:59 pm)

The pulse pattern is a function of the scope settings (they should trigger on the leading edge of the pulse and not so slow as to show a train of pulses). Apparent voltage on the cell is gap/dialectic of water derived, most people don't know but pure distilled water is non conductive to electricity! Deionized water would be a suitable sub. To determine droplet size/injector requires some pretty heady calculus. Tune freq for a drop in electrode amps which will give you the highest plate voltage.

freeenergy4everyone (December 31, 1969 at 6:59 pm)

Check out the pulse pattern for idle on the Wfc injector plug , he was also trying to work out the droplet of water size per injector cycle to power a 1000hp engine.....Also reports that Meyers Cell produced upto 40kv in the cell, with less than half an amp aplied current

RFvideoProductions (December 31, 1969 at 6:59 pm)

Disassociation is enticed by voltage potential building up higher and higher as resonance is approached. There is not enough time for built up potential to dissipate (leakage) before the next cycle. When enough potential is present the molecules start to disassociate in a cascading effect very similar to the knee voltage of a zener diode. No (or very little) current is present as there are very few electrons being freed (contaminates in the water??).

freeenergy4everyone (December 31, 1969 at 6:59 pm)

as there is no current flow this is alot easier than you think! Bifilar?? You follow me? Please reply privatley

aphor (December 31, 1969 at 6:59 pm)

I floated this idea past some experimental physics PhDs I know, and it's testable, but computationally HARD to do the math... multiple H2O molecules would all dance to special resonant EMF, in polar alignment. Resonant EMF would also gently nudge electrons away from the O forming H2 skipping the higher energy O+ or H- ion states. Total energy required to drive the molecular/quantum dance could be orders of magnitude less than electrolysis. Think of it as finessing entropy.

freeenergy4everyone (December 31, 1969 at 6:59 pm)

Yes very true. this means that he was losing .5 amps or less through his Vic and water cell to earth through electron leakage. If the leakage was through the bifilar or inductors it would short the whole thing out.